Labconco Protecto Downdraft Powder Station 3410025 - Manual (Page 9)

Chapter 3: Getting Started
Product Service 1-800-522-7658 5
The work surface and work surface pan are shipped unassembled to the filter
module. To assemble the station:
1) Engage the notches on the front of the pan with the pins located in the
bottom corners of the filter module, as shown in Figure 3-1.
Engage the work surface pan
With the lower pins on the side
of the filter module.
2) Set the work surface on top of the pan by hooking the rear flange
under Ensure the work surface flange goes behind the front panel the
bottom edge of the filter cover, as shown in Figure 3-2.
Figure 3-1
Figure 3-2
Ensure the work surface
flange goes behind the
front panel.