Labconco Protecto Downdraft Powder Station 3410025 - Manual (Page 14)

Chapter 4: Performance Features and Safety Precautions
Product Service 1-800-522-7658 10
Safety Precautions
NEVER USE THIS STATION WITH HAZARDOUS CHEMICALS OR
BIOHAZARDS. FAILURE TO DO THIS CAN RESULT IN
EXPOSURE TO THESE HARMFUL CONTAMINANTS. This station is
intended to be used for the containment of nuisance powders only.
Ensure that the station is connected to electrical service in accordance with
local and national electrical codes. Failure to do so may create a fire or
electrical hazard. Do not remove or service any electrical components
without first disconnecting the station from electrical service.
When handling evidence, or working in the station, always wear appropriate
personnel protective equipment.
NEVER use the station without a prefilter installed; this could result in
premature loading of the HEPA filter
NEVER attempt to dust evidence containing flammable gases or solvents in
the station. An open flame should NOT be used in the station.
HEPA filters only remove particulate matter. Operations generating volatile
toxic chemicals are prohibited. The media of the filter is fragile and should
not be touched. Avoid puncturing the HEPA filter during installation or
normal operation. If you suspect that a HEPA filter has been damaged, DO
NOT use the station; contact Labconco at 800-821-5525 or 816-333-8811 for
further information.
The HEPA filter in the station will gradually accumulate airborne particulate
matter from the powder and from airborne particulates. The rate of
accumulation will depend upon the cleanliness of the air, operating time and
the amount of powder being used in the station.
Do not operate the station without all of the appropriate filters in place.
When handling used filters or prefilters, always wear appropriate personnel
protective equipment.