Labconco Protector Storage Cabinets 99071 - Manual (Page 26)

22
Product Service 1-800-522-7658, International 816-333-8811
Chapter 3: Getting Started
SpillStopper™ Work Surface
Once your cabinet has been properly leveled, vented
(optional), and filler panel installed, place the epoxy
work surface directly on top of the cabinet. It is not
necessary to attach the work surface to the cabinet. It is
held in place both by its own weight and the weight of
the fume hood and other equipment on top of it. Align
the work surface on top of the cabinet before making
plumbing or electrical connections through the work
surface itself. Normally, the work surface is aligned
flush with the top front of the cabinet and overhangs the
back of the cabinet.
WARNING: Never use screws and/or
bolts to fasten the epoxy molded work
surface directly to the cabinet as this
can damage the work surface.
!
A S
B V