Laerdal SimView - Manual (Page 10)

10
5.5 Adding a microphone
To add a microphone to the simulation setup, start Session Viewer and the click the
“Setup system or start video recording” on the start window.
1. From the Home screen click the “Add equipment” (1) (You may have to scroll down).
2. Click to enable the drop down menu (2) box.
3. Select Microphone from the drop down list (3).
4. Click the “Add equipment” (4)
5. The Microphone is active by default.
6. If you want to add another device click the “Add equipment” button (1) again and continue until
you have added all the needed devices installed.
After you have installed the microphone, you have some options. If you have added audio equipment to the
line input, you may have to select which channel the audio should be taken from, as the Session Viewer only
records in mono. On Figure 20 you can see the options, enable the drop down list (5) and select the option
you want, then press save changes(6).
Figure 17 Add microphone or audio equipment
Figure 18 Select microphone
Figure 19 Select the wanted microphone
Figure 20 Microphone and audio options