Pitney Bowes DM875 Series - Manual (Page 166)

9 • Maintaining and Updating
9 - 6 SV62200 Rev. C
Cleaning or
Replacing the
Moistener Brush 1. Lift the feed cover.
2. Push down on the moistener brush button.
3. Grasp the moistener brush assembly and pull it straight out towards
you.
4. Clean the moistening brush by running the brush under warm water.
5. If you need to clean or replace the wick, go to Cleaning or Replacing
the Wick procedure below. Otherwise go to step 6.
6. Replace the existing clean moistener brush assembly, or install a new
one by pushing the assembly back on its track until it snaps into posi-
tion.
7. Verify that the moistener brush assembly is perfectly level with the feed
deck.
Moistener brush button
Moistener brush assembly
Moistener brush
Clean here to
ensure it is free of
dirt and grime