Pitney Bowes DM875 Series - Manual (Page 35)

DM825™ and DM875™Series Digital Mailing System Operating Guide
SV62200 Rev. C 3-3
4. Place the stack of mail on the feed deck shown in the picture below.
• Place the envelopes with the flaps down and against the rear
wall.
• Make sure the envelopes are pushed far enough so that they
cover the feed sensor on the rear wall.
5. Adjust the side guide so it is close to, but not touching, the bottom edge
of the envelope stack. Be sure and leave a slight clearance between
the side guide and envelopes (about 1/16 inch clearance).
6. Adjust the thickness adjustment knob to
adjust for envelope thickness. For
thicker pieces of mail (3/8” to 5/8”), or
mail containing several inserts, use the
thick mail setting. For mail containing
only single inserts, or for postcards, use
the normal mail setting. Refer to the fig-
ure on the right.
To pick a setting, turn the knob to the
arrow located on the feed cover.
7. Make sure you have sufficient funds in
your postage meter. If the message
“Low Funds” appears on the screen,
make sure you can complete the mail
run with the funds you have. If you do
not have enough funds, see Chapter 6,
Adding Postage in this guide. uide and
envelopes (about 1/16 inch clearance).
Running the
Mail 1. Press the Mode key on the IntelliLink® Control Center.
2. Select Key In Postage.
3. Key in the correct postage value using the numeric keys on the control
center, then press the Enter key.
4. Place the piece of mail on the feed deck and press the Start key.
Feed
Sensor
Side Guide
Thin Mail Setting
Thick Mail Setting