Rocktron VooDu Valve - Manual (Page 81)

79
Step 8 Turn the PARAMETER SELECT control one step clockwise to display the Upper Limit
parameter (for PARA1).
ULIM C1 XXX
Step 9 Use the PARAMETER ADJUST control to choose the highest value that the parameter is not
to exceed through MIDI control changes.
ULIM C1 -2
Step 12
Step 13
Step 10
Step 11
Use the PARAMETER ADJUST control to select the lowest value which the parameter is
not to fall below through MIDI control changes.
Selecting a lower limit value that is greater than the upper limit value will invert the
response of the controller - i.e. the toe position of the expression controller will provide
the minimum value, while the heel position will provide the maximum value.
NOTE: Steps 1-13 are repeated seven times for a total of eight controllers. To exit Controller
Assign at any time, turn either the PRESET or FUNCTION SELECT control. Only changes
that have been stored will be saved after exiting the Controller Assign function.
After selecting a value for the lower limit, press the STORE button to save it. "STORED" will
flash briefly on the display.
LLIM C1 - ∞
Turn the PARAMETER SELECT control one step clockwise to access the Lower Limit
parameter (for PARA1).
After selecting a value for the upper limit, press the STORE button to save it. "STORED" will
flash briefly on the display.
STORED
LLIM C1 -12
STORED