Rocktron VooDu Valve - Manual (Page 98)

96
Step 4 Press the STORE button at this time to initiate the All Restore procedure and erase all current
Voodu Valve presets, replacing them with the original factory presets. The Voodu Valve will
display "INITIALIZING" as the Voodu Valve memory is restored.
INITIALIZING
After the All Restore process is completed, the display should read "ERRORS 0". This is the
number of bytes that the Voodu Valve found that did not initialize properly. Any number of
errors other than "0" means that the Voodu Valve may not have initialized properly and the
process should be repeated.
ERRORS 0
The Voodu Valve will remain in this condition until the FUNCTION SELECT control is turned
to exit the Factory Restore function. The preset currently recalled will be the preset most recently
restored into the current location.
The controller assignments for the Voodu Valve can also be reinitialized without affecting
presets and other stored information. Reinitialization of the controller assignments is necessary
when setting up the Voodu Valve to operate in remote mode with a Rocktron All Access™
footswitch.
To reinitialize only the controller assignments, enter a code number of "221" at Step 3 on
the opposite page.
Restoring the Voodu Valve controller assignments: