SpectraCal CalMAN for SCRATCH Plug-In User Manual
Page 10
17544 Midvale Ave. N. Shoreline, WA 98133 USA
Corporate: +1 206 420 7514 | Tech Support: +1 206 457 8949 |
Load CalMAN LUT file into ASSIMILATE SCRATCH
Follow this procedure to load the 3D LUT you just created into ASSIMILATE SCRATCH, as a display
calibration LUT.
To load the CalMAN 3D LUT into SCRATCH:
1. Right click on the SCRATCH project screen to display the SCRATCH menu and select Settings.
2. At the lower left of the screen, select Monitor.
3. For the target monitor, click the “Load” button, then navigate to the drive location where you
specified the CalMAN LUT to be saved. If you did not specify a location, the default CalMAN LUT
file location is: \Documents\SpectraCal\CalMAN 5 for Business\LUTs.
4. Select the LUT file to load it for the target monitor.
5. Click the "Apply Colorspace" button on the SCRATCH screen to enable it.
6. Click the “Apply LUT” button to enable or disable LUT correction.
NOTE: Each monitor requires its own 3D calibration LUT. SCRATCH can apply a separate LUT to its
Interface monitor and to its Dual Head RGB or Dual Head SDI output monitor.