SpectraCal CalMAN for SCRATCH Plug-In - Manual (Page 5)

17544 Midvale Ave. N. Shoreline, WA 98133 USA
Corporate: +1 206 420 7514 | Tech Support: +1 206 457 8949 | www.spectracal.com
Display Calibration
Follow this procedure to:
a. Create a display calibration 3D LUT file for an RGB interface monitor, a dual head RGB output
monitor, and/or a dual head SDI video display driven from ASSIMILATE SCRATCH.
b. Load the 3D LUT file(s) into ASSIMILATE SCRATCH.
c. Verify the calibrated display performance.
Create Display Calibration 3D LUT
Proceed through each step of the Color Cube workflow in the normal fashion, using the following notes
for ASSIMILATE SCRATCH specifics.
1. Initial Setup section
In the ‘Initial Setup’ section of the Color Cube workflow, step through the
following pages:
a. Session Setup - Meter Connect
1. Connect your color meter to the CalMAN computer.
2. On the Session Setup page, click the Find Meter button.
3. If your meter is listed on the Find Meters dialog, select it, then
click Search. If your meter is not listed on the dialog, just click
Search.
4. Position the meter on the target monitor.
b. Session Setup - Source Connect
1. On the CalMAN Session Setup page, click the Find Source button.
2. On the Source dialog, under Manufacturer, select “ASSIMILATE.”
3. Under Model, select “ASSIMILATE – SCRATCH Pattern Generator.”
4. Select the IP address of the target computer to be calibrated.
5. Click Connect.