SurgeX SX-20NE-RT-AR - Manual (Page 12)

SX-20NE-RT-AR User Manual
Page 11
VI. Web Server
The Axess Ready web interface provides the easiest means of operating the outlet and
changing configuration parameters.
To access the web interface, open a web browser and enter the IP address of the AR into
the address bar. The factory default IP address is 192.168.1.254.
Password
The AR uses two username/password credential sets, one for normal power control (user)
and one that also provides access to the Setup functions (admin).
Default credentials:
Role Username (fixed) Password (user set)
Administrator admin admin
User user user
Enter a valid username and password when prompted.
When the proper username/password combination is
received, the Control and Status Page is displayed.
Control and Status Page
Once a user is validated, the Control and Status page is
displayed.
Note: Only one user may be logged in to the AR at a time.
Press “Power On” or “Power Off” to turn the AC output On
or Off. In the event of a power outage, the AC output will
return to its last known state prior to the outage.
Press “Cycle Power” to temporarily change the state of the
AC output for a specified cycle time (factory default is 10
seconds). The cycle operation performed will either be On-Off-On or Off-On-Off, depending
on the initial state of the AC output. During the power cycle operation, the Power Status bar
will indicate the temporary status with a Blue background. Once the cycle is complete, the
status bar will revert to its original condition. To abort a power cycle, press either “Power On”
or “Power Off” and the outlets will assume that status.
If the AutoPing feature is in use, this page will also display the current status (OK or Failed)
for each AutoPing, a counter of how many times the ping failed, and a counter of how many
times the defined action was triggered. Reset buttons for the Fail and Trigger counters are
available for the admin login.
Use the Refresh button to update the page with the most current status. Use of the
browser’s refresh button may lead to inadvertent power switching. If an NTP time server is
being used, the time of the last refresh will be displayed in the upper right corner.