I. introduction – SurgeX SX-20NE-RT-AR User Manual

Page 4

Advertising
background image

SX-20NE-RT-AR User Manual

Page 3


I.

Introduction

The SurgeX

®

SX-20NE-RT-AR is a network attached, IP addressed, web controlled AC surge

eliminator and power conditioner. The SX-20NE-RT-AR may be used to switch up to 20A at
120V. The simple web server structure allows basic control of one branch circuit. The extensive
programming and setup capabilities are accessed by a web browser, through a Device
Management Utility (DMU), or through a Command Line Interface (CLI).

• The SX-20NE-RT-AR features a magnetic shielding NEMA steel enclosure, SurgeX

®

Advanced Series Mode

®

surge elimination, Impedance Tolerant EMI/RFI filtering,

SurgeX ICE

®

Inrush Current Elimination, and low level control inputs/outputs.

• Remote reboot any device: monitors, routers, servers, kiosks, etc. The remote device

need not be network attached.

• Conserve energy by powering down equipment when not in use.

• Telnet access uses the Command Line Interface (CLI) structure and syntax to

completely configure and control the SX-20NE-RT-AR. This Axess Ready (AR)
device also supports the DxP protocol, which allows software developers to integrate
the unit into custom applications.

• Up to 2 systems can be continuously monitored with AutoPing, with automatic power

control upon loss of contact. Reboot crashed systems, or provide auto power-up or -
down for environmental controls and notification systems.

• The SX-20NE-RT-AR utilizes 2 levels of password security, with only the

administrative account having access to setup and configuration.

• Accepts both DC voltage and contact closure control inputs.

• Two or more units can be cascaded together for larger systems.

• Auxiliary relay output can be used to control other SurgeX® products.

• 12 Volt DC output can be used to control other SurgeX® products or drive LEDs.

• Auxiliary relay or 12 Volt DC output can be used to provide confirmation feedback.

• 12” x 12” x 4” NEMA enclosure meets electrical code for use at the service entrance,

sub-panels, and in ceiling plenums.

Advertising