SurgeX SX-20NE-RT-AR - Manual (Page 19)

SX-20NE-RT-AR User Manual Page 18
VII. Command Line Interface (CLI) Protocol
The Command Line Interface provides complete setup of all functions of the AR. The CLI may be accessed through the Telnet
protocol, and requires a Telnet client program. Some commands of the CLI require administrative rights; these are indicated in the
following tables.
Prompts
Prompt Description
User> Prompts the user to enter the user name (either user or admin).
Password> Prompts the user to enter the password.
Axess Ready> Prompt displayed while logged in.
Axess Ready Reboot Required> Prompt displayed after changes have been made that require a reboot. This
prompt will remain active until the AR has been rebooted.
Control Commands
Command Description Admin Fact Def
get outlet Returns the current status of the outlet. No
set outlet < on | off | cycle > Sets the outlet to the selected state. No
Device Commands
Command Description Admin Fact Def
get location Returns the location ID. Yes Axess
Ready
set location < 20 character max > Sets the location ID. Yes
get cycle Returns the cycle time currently in use in seconds. Yes 10
set cycle < 1-999 > Sets the cycle time in seconds. Yes
get upgrade enable Returns the upgrade enable status. No Disabled
set upgrade enable < yes | no > Enables or disables the ability to upload new
firmware. Yes
Logout Terminates the telnet session. No
Reboot Reboots the AR. Yes