Taser CAM - Manual (Page 11)

11 Chapter 3 Charging
5 Connect the wall power cable to a wall outlet.
6 A green light near the TASER CAM lens will flash to indicate charging.
7 When charging is complete, the green light will remain steady.
8 After unplugging the charging cable from the TASER CAM recorder, remember to replace the dataport plug
on the TASER CAM recorder to prevent damage from any debris or moisture.
NOTE: Never remove the TASER CAM recorder from the ECD while the safety is in the up (ARMED) position.
If the TASER CAM recorder is charging while it is in the X26 ECD, the right half of the X26 CID will display a
sequence of numbers. When the battery is fully charged, three horizontal segments will be displayed.
NOTE: When the USB download cable or wall charging cable is disconnected from the TASER CAM recorder
while in the X26 ECD, the X26 ECD will go through its boot-up sequence as if a DPM/XDPM battery pack were
removed and reinserted. Never remove the TASER CAM recorder from the X26 ECD while it is going through the
boot-up sequence, or while the safety is in the up (ARMED) position.