Taser CAM - Manual (Page 15)

15
Operation
6
Operating the TASER CAM System
When the TASER CAM recorder is inserted into an X26 ECD and disconnected from an external charging source
(PC or wall power), it provides power to the ECD and to the sensitive camera and microphone used by the TASER
CAM recorder.
Install the EVIDENCE Sync software on your computer, update the X26 and TASER CAM devices’ firmware, and
configure your TASER CAM recorder before attempting to use it with the ECD. See Chapter 3: Charging the
TASER CAM Recorder and Chapter 5: Configuring the TASER CAM Recorder with EVIDENCE Sync Software.
Testing the TASER CAM Recorder
1 Disconnect the TASER CAM recorder from the PC or wall power and remove the charging cable from the
recorder.
2 Confirm that the X26 safety is in the down (SAFE) position.
3 Remove the TASER cartridge from the X26 ECD. (See the TASER X26E ECD User Manual for more information
on unloading TASER cartridges.)
4 Confirm that the charging cable is removed from the TASER CAM recorder.
5 Firmly insert the TASER CAM recorder into the ECD until it clicks and the X26 ECD’s ejector button pops out
completely.
• If the X26 weapon software is an older revision, the TASER CAM recorder will update the software. A “P”
will appear on the X26 CID indicating that the weapon software is being updated. DO NOT REMOVE THE
TASER CAM RECORDER UNTIL THE SOFTWARE UPDATE AND BOOT UP SEQUENCE IS COMPLETE. DOING
SO WILL CORRUPT THE SOFTWARE IN THE X26 ECD.