Datalogic Scanning MAGELLAN 1400I - Manual (Page 64)

Interface Related Features
3-36 Magellan
®
1400i
Keyboard Wedge — cont.
Intercharacter Delay
NOTE
This feature does not apply to the USB Keyboard interface.
START / END
PROGRAMMING BAR CODES
One-half of the delay specified below is inserted between scancodes within each character. If the transmission speed is too high, the
system may not be able to receive all characters. You may need to adjust the delay to make the system work properly. Selectable
from 000 to 255 in 10msec increments. To configure this feature, scan the “START/END” bar code above to place the unit in Pro-
gramming Mode, then the “Set Intercharacter Delay,” followed by the three digits (zero padded) from the Alphanumeric table in
Appendix C, Alpha-Numeric Pad representing your desired length. Exit programming mode by again scanning the “START/END”
bar code above/
DEFAULT SETTING FOR THIS FEATURE:
000 (No Delay)
Set Intercharacter Delay