Velodyne DS-10 - Manual (Page 37)

previously. To save optimization settings:
1. Press the ExIT button on the remote, or position the cursor over the SAVE/ExIT field on either the System Settings screen
or the System Response screen.
2. The SAVE SETTIngS? prompt appears with yES selected as shown in Figure 10.
3. Press SELECT to save settings.
Figure 10: System Settings Screen Save Settings
• Selecting yES and then pressing SELECT on the remote button, saves your settings and reboots the subwoofer, returning
you to the Introductory screen.
• Selecting nO and then pressing SELECT on the remote button, returns you to the Introductory screen without saving; the
previous settings saved in memory are used.
• Selecting CAnCEL and then pressing SELECT on the remote button, keeps you on the current screen.
4. While the subwoofer is saving its settings, you will see the video flicker and you may hear a slight pop from the subwoofer.
The subwoofer then displays the default preset and the volume. This is normal behavior.
Select a Preset
To select which preset you want to Manual-EQ, be sure to have the microphone connected to the subwoofer and the sweep tone output is
playing through the subwoofer and that you’ve connected the sweep tone output from the subwoofer into your audio system. See the how to
Connect the eQ output From the Subwoofer to Your audio System section.
1. Position the cursor in a preset column (you cannot select the heading) on the System Settings screen.
2. Press TEST.
OR
1. Highlight the PRESET field on the System Response screen.
2. Use the SET +/- buttons on the remote to select a preset.
OR
1. Press a preset button on the remote on either the System Settings or the System Response screen.
Make & Save Preset Changes
The simplest customization of parameters you can do is to make and save changes to the presets.
[ 34 ]
TV SCREEN INTERFACE FOR OPTImIZATION
Digital Servo User’s Manual