Voodoo Lab Ground Control(Original Version 2) - Manual (Page 12)

11
D I G I T A L M U S I C C O R P O R A T I O N
Note: Each device in your system must be set to its own MIDI
channel to respond properly.
Start Number
Most devices number their programs starting from 1. If your
device starts numbering its programs from 0, then the device
will always be off by 1 from what is displayed on the Ground
Control. You can fix this by telling the Ground Control that it
should "start at 0". Here's how:
1. Press [SELECT
∧ or ∨] to choose the device 1-8 that you
need to change.
2. Press and hold [CURSOR >] until the display reads:
STARTS AT 01
3. Press [-/NO] to select "STARTS AT 00" or press [+/YES]
for "STARTS AT 01".
Expression Pedals
¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯
To use guitar volume pedals as MIDI expression pedals, you
must enable and calibrate them here.
After entering Setup mode, activate this function by pressing
[LEARN PEDAL]. The display should read:
P1 IS OFF
To enable (turn on) the pedal connected to "PEDAL 1", press
[+/YES]. To disable (turn off), press [-/NO].
Slew
Now press [CURSOR >]. The Ground Control will display:
P1 SLEW=NORM
Slew refers to the response of the Pedal as you sweep it from
full off to full on. You can select between Normal and Fast. In