Voodoo Lab Ground Control(Original Version 2) - Manual (Page 9)

8
D I G I T A L M U S I C C O R P O R A T I O N
¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯
If you plugged a volume pedal into the Ground Control to use
as an Expression Pedal, set your device to respond to MIDI
Continuous Controller 007. If you don't know how to do this,
see the owner's manual for your device.
Your volume pedal must be plugged into the Ground Control's
"PEDAL 1" jack. Enable the Expression Pedal from Setup
mode. Here's how:
1. Press both [SETUP MODE] buttons (numbers 5 and 0) at
the same time to enter Setup mode.
2. Press [LEARN PEDAL] (button 7).
3. The Ground Control will display "P1 IS OFF". Press
[+/YES] to turn Pedal #1 ON.
4. Exit Setup mode by pressing either [SETUP MODE]
button, then press [+/YES].
If Program Numbers Don't Match
¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯
Some devices number their programs starting at 0 instead of 1.
If your programs are off by 1 you can correct it as follows:
1. Press both [SETUP MODE] buttons at the same time.
2. Press [DEVICE NAME/MIDI CHANNEL].
3. The Ground Control displays "1.DEVICE /01". Press and
hold [CURSOR >] until the display says "STARTS AT 01"
4. Press [-/NO] to set the start number to 00.
5. Exit SETUP MODE by pressing either [SETUP MODE]
button, then press [+/YES].