Voodoo Lab Ground Control(Original Version 2) - Manual (Page 23)

22
D I G I T A L M U S I C C O R P O R A T I O N
If you have more than one MIDI device, you must specify
which one the Expression Pedal should control. Press
[CURSOR >] to get to the following display:
P1->TRIAXIS
↑ ↑
Pedal Target Device
Press [DATA] to choose the desired device.
Controlling the System Mix Plus VCA
¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯
Before controlling the System Mix Plus VCA, you need to
enable it from Setup mode.
For each Ground Control Preset, you can assign a specific
volume level, or you can control the volume with expression
pedals, or do both.
Controlling the VCA with Preset Volume Levels
Volume changes can be programmed for each preset. Press
[SELECT] until you see the display:
VCA LEVEL --
A value of "--" means no preset volume change will be sent
when the preset is recalled. Press and hold the [DATA] buttons
to enter a preset volume level from 00 (off) to 99 (maximum).
Controlling the VCA with Expression Pedals
To control the VCA with expression pedals, you set them up
just like in "Using Expression Pedals" above. Press [SELECT]
until you get to the pedal display for the desired Pedal (1 or 2):
P1. 064 CTL007