Voodoo Lab Ground Control(Original Version 2) - Manual (Page 21)

20
D I G I T A L M U S I C C O R P O R A T I O N
Assigning MIDI Program Changes
¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯
Use the [SELECT] buttons to choose each of your MIDI
controlled devices. You will see the names of each device that
you entered in Setup mode. It will look something like:
TRIAXIS - 18
↑ ↑
Device Name Program Number
Now enter the number of the program you want for each
device. You can access any program from 0 to 128. For
example:
• For program 6, press [0] [6]
•
For program 36, press [3] [6]
•
For program 112, press [1] [1] [2]
Notice that there is a slight delay when you select programs 10,
11, or 12. This is because the Ground Control is waiting for a
third digit in case you wanted programs 100 through 128.
Note: The Ground Control automatically filters redundant
program changes when Presets are recalled, to avoid
audible glitches.
You can also instruct the Ground Control to not send a MIDI
Program Change. How you do this depends on whether your
device numbers programs from 0 to 127, or from 1 to 128 (see
"Start Number" on page 11). To not send a MIDI Program
Change, do one of the following:
•
If the device starts at 1, then choose program 0 by pressing
[0] [0].