Dish Network Solo 111 - Manual (Page 12)

Page 8
Chapter 2
Parts of the System
R EMOTE C ONTROL B ATTERIES
The remote control comes with AAA batteries. When you replace old batteries,
you should replace all of the batteries. Use batteries of the same kind, for
example alkaline or carbon zinc, and don’t mix batteries of different kinds.
Alkaline batteries last longer.
1. Press down on the top of the battery cover and slide the
cover off.
2. Take out all of the old batteries.
3. Put the new batteries in. Make sure you match the plus
(“+”) ends with the plus markings inside the battery case.
4. Fit the battery cover’s bottom tab back into the slot at the
bottom of the battery case, and slide the cover back into
place.
U SING THE R EMOTE C ONTROL
The following section describes how to use the remote control with your
satellite receiver.
P OWER B UTTONS
Press the POWER button to turn the receiver ON or OFF.
TV/V IDEO B UTTON
Use this button to switch the receiver between the satellite
programming and another video signal connected into the receiver’s
TV A NTENNA /C ABLE I N input, such as cable or broadcast TV
antenna input.
M ENU B UTTON
Press this button to open the Main Menu .
P AGE U P AND P AGE D OWN (A RROW ) B UTTONS
Press the PAGE UP button or the PAGE DOWN button to scan,
page by page, through the Program Guide , a Theme Categories
list, a Favorite List , an Event Timers list, or a list of channels.