Chapter 4 – Dish Network Solo 111 User Manual

Page 68

Advertising
background image

Page 64

Chapter 4

Installation Instructions

Two Dishes, One DishPro Twin LNBF, One DishPro Single
LNBF, One DishPro Compliant Splitter, Two DishPro 21
Switches, Two Receivers

This diagram leaves out grounding to be clear. Make sure you
ground the system per the National Electrical Code (NEC) and all
local electrical codes.

When you set up your system following this diagram and run

Check Switch

the

Installation Summary

screen should look similar to the one shown

below.

*

* When using a DishPro compliant
splitter to split the signal from a
DishPro single LNBF, the receiver
whose DP21 switch is connected to
the passing side of the splitter must
be plugged into a live power outlet
at all times. If not, the DishPro
single LNBF will not have any
power and will not be able to
provide satellite signal to the other
receiver.

Advertising