Dish Network Solo 111 - Manual (Page 99)

Page 95
FCC Compliance
company will notify you in advance that temporary discontinuance of service
may be required. If advance notice is not practical, the telephone company
will notify the customer as soon as possible. Also, you will be advised of
your right to file a complaint with the FCC if you believe it is necessary.
The telephone company may make changes in its facilities, equipment,
operations, or procedures that could affect the operation of the equipment. If
this happens, the telephone company will provide advance notice in order for
you to make the necessary modifications in order to maintain uninterrupted
service.
If you experience trouble with this equipment, please contact Customer
Service at 1-800-333-3474 for repair and warranty information. If the trouble
is causing harm to the telephone network, the telephone company may
request you remove the equipment from the network until the problem is
resolved.
There are no customer repairable parts inside. Any attempts to
repair the receiver will void your authorization to use it.
Radio Interference
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
1. this device may not cause harmful interference, and
2. this device must accept any interference received, including interference
that may cause undesired operation.
Modifying this receiver may void your authority to use the equipment. This
equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Refer to Troubleshooting in Chapter 5 for a detailed description of
recommended customer actions. If none of the remedies on the previous
page stops the radio interference, you should contact a licensed radio/
television technician, your satellite dealer, or call the Customer Service
Center at 1-800-333-3474, for assistance.