Vortech 1964-1967 Pontiac GTO Carbureted - Manual (Page 17)

9
8. BELT AND BELT TENSIONER INSTALLATION
A. Due to the various pulley diameters and
accessory locations, belts for the factory
accessories will need to be sourced
independently. Installing the belts that
were removed, and marking or cutting them
to the desired length, before purchasing
new belts, may most easily accomplish this.
B. Install all of the accessory drive belts.
C. Loosely install the supercharger belt
tensioner plate onto the face of the
supercharger using 12mm x 20mm bolts
and washers.
D. Install the supercharger belt around the
supercharger and crank pulleys.
E. Install the supplied smooth idler and spacer
onto the belt tensioner plate using 12mm
hardware.
F. Rotate the belt tensioner assembly until the
belt is tight and tighten the bolts.
G. Tighten the supercharger pulley retainer
assembly to 35 ft/lbs if pulley was not
installed at Vortech.
Fig. 8-a
Fig. 8-b