Vortech 1964-1967 Pontiac GTO Carbureted - Manual (Page 25)

P/N: 4GJ020-210 v1.0
©2008 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
12MAR08 v3.0 GTO(4GJ020-210 v1.0)
xxv 17
16. CAC PLUMBING AND BLEEDING SYSTEM
(STANDARD KITS SKIP TO STEP 17)
A. Connect the bottom fitting in the reservoir
to the inlet (center) barb on the water
pump.
B. Connect the top fitting on the CAC to the
upper fitting on the reservoir.
C. Install and tighten the supplied plastic
ratchet clamps on all hose connections.
D. Remove the reservoir cap and fill system
with 25%/75% coolant/water mix.
E. Make sure that all wires and hoses are
routed away from hot, moving or sharp
objects.
F. Key on and verify coolant circulation
through the system. Check for leaks. If
water is not flowing, remove the hose from
the water pump discharge to prime the
pump, by flowing some water through the
system. Reconnect the hose and verify
circulation. Do not run the water pump for
extended periods (30 seconds or more)
without water flow.