Vortech 2010+ Camaro Fuel Pump Voltage Booster - Manual (Page 14)

DP/N: 007124v1.0
© 2010 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured.
08FEB2010 FPVB UPGRADE
8
A. Locate the red with white stripe wire, fourth row
down from the top on the right side when viewing
the fuse block from the back.
B. Cut the wire approximately two inches from the
back of the fuse block as shown.
C. Strip both ends of the cut wire.
D. Locate the wire harness supplied with the Fuel
Pump Booster (FPVB)
E. Temporarily plug the FPVB harness into the con-
nector on the FPVB unit. Route the orange signal
wire and red “PUMP +” wire along side the OEM
wiring so that it meets up with the OEM fuse block
location. Cover the wires with the supplied split-
loom and secure with zip ties. Unplug the FPVB
harness from the FPVB unit.
F. Trim the red and orange FPVB wires to the proper
length, as they will be soldered into the previously
cut red with white stripe OEM wires.
3. FUEL PUMP VOLTAGE BOOSTER WIRING
Fig. 3-a
Fig. 3-b
Fig. 3-c
RED/WHITE
WIRE TO CUT
APPROX.
2 INCHES