Vortech 2010+ Camaro Fuel Pump Voltage Booster - Manual (Page 4)

DP/N: 007124v1.0
© 2010 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured.
08FEB2010 FPVB UPGRADE
iv iv
VORTECH FUEL PUMP VOLTAGE BOOSTER
Installation Instructions
2010 CHEVROLET CAMARO SS
Before beginning this installation,
please read through this entire instruction booklet
The Vortech 2010 Camaro Fuel Pump Voltage Booster (FPVB) upgrade was designed
specifically for use on 2010 Chevrolet Camaro SS vehicles equipped with a supercharg-
er to support applications with increased horsepower over the basic kit. As with any
power enhancing product, this unit is intended for use on healthy, well-maintained
engines. Vortech Engineering is not responsible for engine damage. Installation on new
vehicles will not harm or adversely affect the break-in period so long as factory break-in
procedures are followed.
For best performance and continued durability, please take a note of the following key
points:
1. Use only premium grade fuel 91 octane or higher (R+M/2).
2. Always listen for any sign of detonation (pinging) and discontinue hard use (no
boost) until problem is resolved.
TOOL & SUPPLY REQUIREMENTS:
• Open End Wrenches (5/16”, 10mm)
• 3/8” Ratchet
• 10mm, 13mm, and 5/16” Sockets
• Flat #2 Screwdriver
• Phillips #2 Screwdriver
• Utility Knife
• Heat Gun
• Soldering Iron/Gun
• Electrical Tape
• Wire Cutters, Strippers and Crimpers
• Drill Motor
• 1/8”, Drill Bit
• Tape Measure