Vortech 2010+ Camaro Fuel Pump Voltage Booster - Manual (Page 15)

DP/N: 007124v1.0
© 2010 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured.
08FEB2010 FPVB UPGRADE
9
3. FPVB WIRING , CONT’D
G. Cut two 1” pieces of supplied heat shrink sleeve
and slide one each over the red “PUMP+” and
orange wires.
H. Solder the orange wire to the red with white stripe
wire, previously cut, leading back to the fuse block
I. Solder the red “PUMP+” wire to the red with white
stripe wire, previously cut, leading into the cars
wiring harness.
J. Pull the heat shrink sleeve over the two soldered
connections and properly shrink with heat gun to
protect the connections.
K. Reattach the rear cover to the back of the fuse
block.
Fig. 3-d
Fig. 3-e
BATTERY FPVB
FUSE
BLOCK
RED “PUMP +”
BLACK “BATT -”
RED “BATT +”
SOLDER
CONNECTIONS
ORANGE
OEM WIRE
(RED/WHITE STRIPE)
SOLDER
CONNECTION
FUSE HOLDER
W/ 40 A FUSE
Fig. 3-f
Fig. 3-g