Vortech 2010+ Camaro Fuel Pump Voltage Booster - Manual (Page 16)

DP/N: 007124v1.0
© 2010 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured.
08FEB2010 FPVB UPGRADE
10
3. FPVB WIRING , CONT’D
L. Remount the fuse block to the trunk wall and
snap in place.
M. Reinstall the cover onto the fuse block.
N. Using the remaining split loom and zip ties, route
the black "BATT-" and red “BATT+” wires from
the harness plug to each of the respective bat-
tery terminals. (Red to battery positive and Black
to battery negative/ground)
O. Trim and strip the black "BATT -" wire to length
and crimp on a blue supplied ring terminal.
P. Using a 10mm socket or wrench, attach the ring
terminal to the factory battery terminal as shown.
Q. Locate the supplied fuse holder. Cut and strip
both ends of the wire at the middle.
R. On one end of the fuse holder, crimp on the sup-
plied yellow ring terminal.
S. With fuse NOT installed in fuse holder, attach the
yellow ring terminal to the positive factory battery
terminal, using a 10mm socket or wrench.
Fig. 3-h
Fig. 3-i
Fig. 3-j Fig. 3-k
NOTE: Do NOT reattach to battery at this time.
ATTACH BLUE
RING TERMINAL
HERE
ATTACH
YELLOW RING
TERMINAL HERE