Vortech 2010+ Camaro Fuel Pump Voltage Booster - Manual (Page 17)

DP/N: 007124v1.0
© 2010 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured.
08FEB2010 FPVB UPGRADE
11
3. FPVB WIRING , CONT’D
T. Trim and strip the red "BATT +" wire to length to
mate up with the other end of the fuse holder.
U. Cut a 1" piece of the supplied heat shrink and
slide over the end of the red "BATT +" wire
V. Solder the end of the red "BATT +" wire to the
fuse holder wire.
W. Pull the heat shrink sleeve over the soldered
connection and properly shrink with heat gun to
protect the connection. Tape with electrical tape
to ensure a sealed connection.
X. Cover wires with supplied split loom and secure
with zip ties.
Y. Trim positive battery terminal cover as necessary
for the lid to shut securely.
Z. Install 40A fuse into fuse holder and close fuse
holder cover.
Fig. 3-l
Fig. 3-m
Fig. 3-n Fig. 3-o
SOLDER,
HEAT SHRINK,
AND TAPE