Waldorf Largo - Manual (Page 46)

Sound Parameter
Largo User´s Manual 46
w
The Parameter Controls of all envelopes are nearly
similar.
w
A detailled introduction of the envelopes can be
found in the Appendix of this manual.
The ADSR Envelope
Click on one of the handles in the envelope graphics to
continuously and smoothly change the envelope
parameters or click into any envelope phase to let its
value jump here.
Attack 0...127
Determines the attack rate or amount of time it takes for a
signal to go from zero to maximum level.
Decay 0...127
Determines the decay rate or amount of time it takes for a
signal to reach the Sustain level.
Sustain 0...127
Determines the sustain level which is held until a note
ends.
Release 0...127
Once the note has ended, the release phase begins.
During this phase, the envelope fades to zero at the rate
determined by the Release value.
Trigger Multi / single
Determines the triggering of the Filter Envelope.
• Multi means that every Note starts the filter
envelope of its own voice.
• Single means that the envelopes of all voices of a
selected program behave like a single envelope.
This common envelope starts as soon as the first
note is played. The sustain level remains until the
last note is released. Afterwards the release phase
is active.
Mode ADSR / ADS1DS2R / One Shot / Loop S1S2 /
Loop All
Pop-up menu to switch between the various envelope
types. Please refer to the Appendix for detailled
explaination of all the types.