Waldorf Largo - Manual (Page 62)

Sound Parameter
Largo User´s Manual 62
Depth 0…127
Sets the modulation depth of the Phaser effect.
Center 0…127
Controls the basic delay length of the allpass filters. Lower
settings produce a high pitched Phaser effect while higher
settings enable the Phaser to cover deeper frequencies.
Spacing 0…127
Controls the relative frequencies of the allpass filters. A
setting of 0 produces a classic phaser, while higher
settings spread out the frequencies of the allpass filters.
Feedback 0…127
Controls the feedback amount of the delay signal.
Polarity positive / negative
Determines whether the feedback signal is fed back into
the Phaser as is, or is inverted beforehand.
Overdrive
The Overdrive effect distorts the input signal by
amplifying it drastically and clipping the resulting signal
to a certain output level. The difference between this
Overdrive effect and the Drive parameter of the Filter
sections is that Drive affects one single voice, while this
effect type distorts the summed output of the whole
instrument. Therefore, the resulting effect is different as
soon as you play more than one note and you should
consider which is best suited to a particular sound
program. The Overdrive effect, for example, works great
on Organ or E-Piano sounds.
Drive 0…127
Controls the amount of distortion the effect produces. Low
values create no or only slight distortion while high values
create heavier distortion.
Post Gain 0…127
Controls the output level of the distorted signal.
Cutoff 0…127
Dampens the high frequency output of the Overdrive
effect.