Remote control mode setup, 2 select the remote control mode setting you want, 3 select “ok” to change the remote control mode – Pioneer VSX-1020 User Manual
Page 106: 5 when you’re finished, press return, Flicker reduction setup, 2 select the flicker reduction setting you want, 3 when you’re finished, press return, The system and the other setup 11
The system and the other setup
11
106
En
Remote Control Mode Setup
• Default setting:
1
This sets this receiver’s remote control mode to
prevent erroneous operation when multiple
units of the receiver are being used.
1
1
Select ‘Remote Control Mode Setup’
from the Other Setup menu.
2
Select the Remote Control Mode setting
you want.
3
Select “OK” to change the remote control
mode.
4
Follow the instructions on the screen to
change the remote control’s setting.
See Operating multiple receivers on page 76.
5
When you’re finished, press RETURN.
You will return to the
Other Setup menu.
Flicker Reduction Setup
• Default setting:
OFF
The GUI screen’s resolution can be increased.
If you feel the GUI screen is hard to see, try
changing this setting. Note this setting only
affects the GUI screen; it has no influence on
the video output.
1
Select ‘Flicker Reduction Setup’ from the
Other Setup menu.
2
Select the Flicker Reduction setting you
want.
3
When you’re finished, press RETURN.
You will return to the
Other Setup menu.
Note
1 If you change this receiver’s setting, also change the setting on the remote control.
VSX-1020_UC.book 106 ページ ２０１０年１月７日 木曜日 午後６時０分