Pioneer VSX-1020 - Manual (Page 76)

Controlling the rest of your system 09
76
En
Chapter 9:
Controlling the rest of your
system
Operating multiple receivers
Up to four receivers can be operated discretely
using this receiver's remote control when
using multiple receivers, provided they are this
receiver models. The receiver to be operated is
switched by inputting the preset code to set the
remote control setting.
• Set the remote modes on the receivers
before using this function (see Remote
Control Mode Setup on page 106).
1 Press and hold the R.SETUP, press “4” for
three seconds.
The LED flashes continuously.
• To cancel the preset setup mode press
R.SETUP.
2 Press the number button for the receiver
(“Receiver 1” to “Receiver 4”) you wish to
operate.
For example, to operate “Receiver 2”, press “
2”.
If the LED lights for one second, the setting has
been successfully completed.
When the preset code is input, the LED flashes
three times to indicate that the setting has
failed.
Setting the remote to control
other components
Most components can be assigned to one of
the input function buttons (such as
DVD or
CD) using the component’s manufacturer
preset code stored in the remote.
However, there are cases where only certain
functions may be controllable after assigning
the proper preset code, or the codes for the
manufacturer in the remote control will not
work for the model that you are using.
If you can’t find a preset code that matches the
component you want to control, you can still
teach the remote individual commands from
another remote control (see Programming
signals from other remote controls on page 77).
Note
• You can cancel or exit any of the steps by
pressing R.SETUP.
• After one minute of inactivity, the remote
automatically exits the operation.
• For greater convenience, assign the TV
connected to the MONITOR OUT terminal
to the
TV CTRL button, and assign your
satellite/cable receiver or set-top box
connected to the TV input terminal to the
TV input button. If a single device is
connected to both terminals, that device
should be assigned to both the
TV CTRL
and TV input buttons.
• Devices may be assigned to the following
input function buttons.
INPUT SELECT ZONE 2
iPod USB TUNER SIRIUS TV CTRL
ADAPTER NET RADIO CD TV
BD DVD
R.SETUP
SOURCE RECEIVER MULTI
OPERATION
DVR/BDR HDMI
RECEIVER
VSX-1020_UC.book 76 ページ ２０１０年１月７日 木曜日 午後６時０分