Ingenico ict220 - Manual (Page 7)

Page 6
5. Key in your Merchant Number and press the GREEN
button.
The terminal will start to dial the Host computer and a
number of communication messages will be displayed.
6. The terminal may then contact any card acquirers it is
configured to accept. Further communication messages
will be displayed.
Dual Comms Mode
You should use the keys to highlight the required
option and then press the GREEN button. For PSTN
installation select Telephone (PPP).
Connection Method
Telephone (PPP)
Local Network
4. Installing the Terminal
Installing the Terminal via PSTN
Before switching the power on at the mains socket, ensure
the mains supply is connected to the circular power port
on the terminal’s connector box.
Ensure the supplied telephone cable is connected to the
telephone IN port on the terminal’s connector box, and
into your telephone socket.
PLEASE NOTE: If you have Call Waiting and select NO when prompted, the terminal will be unable to
dial for authorisation when a call message is waiting.
Position the terminal in a clear area where the display can be read and the keypad and card reader
are easily accessible. Ensure that you have a Merchant Number to hand. This can be found on your
Welcome Letter.
Now switch the power on at the mains supply.
1. Ensure the telephone line is connected to the terminal and to the wall socket and then press the
GREEN button.
If your terminal is connected via a direct line select NO by pressing the YELLOW button.
2. If it is connected to a Switchboard/PABX select YES by pressing the GREEN button.
3. If you selected the Switchboard/PABX option, key in
the number used to get an outside line (often 9) and then
press the GREEN button.
4. If your telephone line has Call Waiting or 1571 press the
GREEN button.
Terminal Installation
Plug in Phone Line
and then press ENTER
Dial Prefix Required ?
Enter=YES Clear=NO
Key in the Number used to get
an Outside Line
and then press ENTER
Does the Tel. Line have
Call Waiting or 1571 ?
Enter=YES Clear=NO
Terminal Installation
Key in Merchant No.
and then press ENTER
Terminal Installation
Connecting to
<Acquirer Name>
Please Wait...