Ryobi BTS10S - Manual (Page 16)

16
ASSEMBLY
TO ASSEMBLE THE LEG STAND
See Figure 6.
Assembly is best done in the area where the saw will be used.
If you are unsure about the description of any part, refer to
the drawing. If any parts are missing, delay assembling until
you have obtained the missing part(s).
 Take the following from a small hardware pack:
16 - 5/16 in. 18-UNC 5/8 in. bolts
16 - 5/16 in. hex nuts
 Take 4 legs and 8 braces from loose parts.
 Place an upper brace inside two of the legs, with the
legs wide end up. (Upper braces have two large holes in
each end.) Make sure the dimples on the leg align with
the small holes on the brace.
 Align the large holes on the brace and the legs. Insert
the bolts. Add hex nuts and hand tighten. Repeat for the
other upper brace. These are the front and back sets.
 For the side sets, install an upper side brace on two legs.
Add hardware and finger tighten.
 Use the same steps to install the lower braces. Tighten
all hex nuts with a wrench.
 Install a foot to the bottom of each leg.
 Move the leg set to desired location.
UNPACKING
This product requires assembly.
 Carefully remove the tool and any accessories from the
box. Place it on a level work surface.
 Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
 Do not discard the packing material until you have
carefully inspected the tool, identified all loose parts, and
satisfactorily operated the tool.
NOTE: Remove the foam block from between the saw’s
housing and the motor.
 The saw is factory set for accurate cutting. After
assembling it, check for accuracy. If shipping has
influenced the settings, refer to specific procedures
explained in this manual.
 If any parts are damaged or missing, please call 1-800-
525-2579 for assistance.
WARNING:
If any parts are damaged or missing do not operate this
tool until the parts are replaced. Failure to heed this warn-
ing could result in serious personal injury.
WARNING:
Do not attempt to modify this tool or create accessories
not recommended for use with this tool. Any such altera-
tion or modification is misuse and could result in a hazard-
ous condition leading to possible serious personal injury.
WARNING:
Do not connect to power supply until assembly is
complete. Failure to comply could result in accidental
starting and possible serious personal injury.
WARNING:
Never stand directly in line with the blade or allow hands
to come closer than 3 in. to the blade. Do not reach over
or across the blade. Failure to heed this warning can
result in serious personal injury.
WARNING:
To avoid serious personal injury, always make sure the
table saw is securely mounted to a workbench or an
approved leg stand. NEVER operate the saw on the
floor.
Fig. 6
CARRIAGE
BOLT
UPPER
SIDE BRACE
UPPER
BRACE
HEX
NUT
LEG
CARRIAGE
BOLT
FOOT
HEX
NUT
LOWER
BRACE