Volvo 2005 C70 - Manual (Page 101)

95
Replacing bulbs
Low beam headlight bulb (A) replacement
1. Turn the plastic cover counterclockwise and remove it.
2. Turn the bulb assembly slightly counterclockwise to release it from
the headlight housing. The bulb and holder are one unit.
3. Pull out the bulb unit.
4. Pry loose the wiring connector from the bulb unit. It may be neces-
sary to use a small screwdriver.
4. Connect the wiring connector to the new bulb unit.
5. Reinsert the bulb and connector into the headlight housing.
6. Turn the bulb unit clockwise until it seats properly in the headlight
housing.
9. Reinstall the plastic cover and turn it clockwise until it is securely in
place.
B - High beam (HB3 bulb) A - Low beam (H11 bulb)
High beam headlight bulb (B) replacement
1. Pull the catch on the lower edge of the cover upward and remove the
plastic cover.
2. Turn the bulb assembly slightly counterclockwise to release it from
the headlight housing. The bulb and holder are one unit.
3. Pull out the bulb unit.
4. Pry loose the wiring connector from the bulb unit. It may be neces-
sary to use a small screwdriver.
4. Connect the wiring connector to the new bulb unit.
5. Reinsert the bulb and connector into the headlight housing.
6. Turn the bulb unit clockwise until it seats properly in the headlight
housing.
6. Reinstall the plastic cover. The catch should snap into position.
CAUTION:
· Do not touch the glass on halogen bulbs with your fingers. Grease,
oil, or ant other impurities can be carbonized onto the bulb and
cause damage to the reflector.
• Be sure to use bulbs of the correct type and voltage.
3501814a