Lenco CR-335 - Manual (Page 13)

13
The ALARM 1 (ALARM 2) LED indicator blinks. The buzzer turns
off for the snooze time (around 10 minutes) then comes on again.
This operation will be repeated five times. After the sixth alarm is
finished , the alarm will shut off until the same alarm time on the
next selected alarm day.
- You may also activate the snooze function manually after the alarm
sounds by pressing the SNOOZE button or wave your hand in front
of the unit at an optimum range 10 to 50 cm (in the case of WAVE
SENSOR was set to ON), see following diagram A. The buzzer
stops for the snooze time then comes again.
- To cancel the snooze before it expires, press the ALARM 1
(ALARM 2) SET button.
- The snooze operation (including auto-snooze and manual snooze)
can be repeated by 5 times only.
- To stop the alarm immediately after the buzzer sounds, you can
also press the ALARM 1 (ALARM 2) SET button. It resets itself for
the next selected alarm day.
Wake to Radio
- When the alarm time is reached, the selected alarm source Radio
will automatically turn on.
- It plays for 60 minutes then shuts off and resets itself for the next
selected alarm day.
- During activation of the alarm source and within 50 minutes from
the set alarm time, you may press the SNOOZE button or wave
your hand in front of the unit at an optimum range 10 to 50 cm (in
the case of the WAVE SENSOR was set to ON) to activate the
snooze function, see following diagram A. The alarm stops for the
snooze time (around 10 minutes) then turns on again.
- To cancel the snooze before it expires, press the ALARM 1
(ALARM 2) SET button.
- Each time the alarm turns on and without pressing the SNOOZE
button or activate the WAVE Sensor, it plays for the remaining
alarm activation time.
The remaining alarm activation time means:
Example A ---- Alarm activates at 12:00, it plays for maximum 60
minutes remaining alarm activation time.
Example B ---- Alarm activates at 12:00 then press the SNOOZE
button at 12:45. The unit goes into snooze mode for 10 minutes. At
12:55, the unit alarm activates again and will play for 5 minutes
remaining alarm activation time.
- To stop the alarm immediately after the alarm sounds, you may
also press the ALARM 1 (ALARM 2) SET button. It resets itself for