Lenco CR-335 - Manual (Page 15)

15
press the POWER button at any time.
Notes:
- If you are falling asleep to music from an external device connected
to the AUX input, the sleep timer will shut off the power to this
system but it will not turn off the external device.
- In power off mode, you can also press the SLEEP button directly to
activate the sleep timer.
Wave Sensing Function and LED Display
You can press the WAVE SENSOR ON/OFF button to enable / disable
the wave sensing function. It works when unit is not in alarm activating or
at snooze mode.
- When the sensor is set to OFF: The LED display always lights
brightly.
- When the sensor is set to ON: The LED display lights normal (dim).
Each time the wave sensor is activated (wave your hand in front of
the unit at an optimum range 10 to 50 cm, see diagram A above)
and the LED display will light brightly for few seconds then return to
normal (dim).
Care and Maintenance
- Do not subject the unit to excessive force, shock, dust or extreme
temperature.
- Do not tamper the internal components of the unit.
- Clean your unit with a damp (never wet) cloth. Solvent or detergent
shoul d never be used.
- Avoid leaving your unit in direct sunlight or in hot, humid or dusty
places.
- Keep your unit away from heating appliances and sources of
electrical noise such as fluorescent lamps or motors.
5. To turn the unit off before the sleep timer counts down to zero,