Lenco DR-05-BT - Manual (Page 11)

INFO mode
Each time you press the INFO button on remote control or MENU/INFO button on the
front panel, the screen will cycle through the following information:
1. RSSI reception
2. Music style— such as <Rock music>
3. Station name — such as <BBC National DAB>
4. Frequency — such as <5A 174.928MHz>
5. Signal error: 25
6. Bit rate — such as <128Kbps/DAB>
7. DLS information
Enter setting menu
Press and hold the MENU/INFO button on the front panel or MENU button on remote
control to enter setting menu, rotate TUNER KNOB to scroll down the menu contents:
<Full scan>→<Manual tune>→<DRC>→<Prune> →<System>
DRC (Dynamic range control)
this is to adapt the dynamic range of the audio signal to listened in a noisy environment.
Note: This function is not always available in many DAB stations.
Steps as below:
1. Press and hold MENU/INFO button on the front panel or MENU button on remote
control, rotate TUNER KNOB to find <DRC> setting.
2. Press ENTER button to enter menu contents and choose DRC Off, DRC High or DRC
Low.
3. Press ENTER to confirm the setting.
This causes the radio to reduce the dynamic range of the audio signal. The purpose of
Prune stations
When the radio has performed a scan in several locations you may find there are some
stored stations that you can no longer receive. This function automatically removes then
from the stored station list.
Steps as below:
1. Press and hold MENU/INFO button, rotate TUNER KNOB to find <Prune> setting.
2. Press ENTER button to enter menu contents and choose YES or NO.
3. Press ENTER to confirm the setting.
System settings
Press and hold
button, to find <System> , press
ENTER button to enter setting menu. Rotate TUNER KNOB to scroll down the menu
contents: <Language> ,<Factory reset> and <SW version>.
MENU/INFO rotate TUNER KNOB
Language
To select the languages of the unit in this section:
1. Press and hold MENU/INFO button, rotate TUNER KNOB to find <System> setting.
2. Press ENTER button to enter menu contents and find <Language> setting.
3. Press ENTER to choose from <English>, <French>, <Deutsch>, <Nederlands>
and <Espanol> .
4. Select one of the languages above, and press ENTER button to confirm.
10