Lenco DR-05-BT - Manual (Page 12)

SW Version
To check the SW version of the unit in this section:
1. Press and hold MENU/INFO button, rotate TUNER KNOB to find <System> setting.
2. Press ENTER button to enter menu contents and find <SW Version> setting.
3. Press ENTER to see the SW version of this unit.
1. Enter FM mode
Press the SOURCE button to enter the FM mode. (Frequency: 87.5-108.0MHz) Press
MO/ST button on remote control to turn stereo on, if the reception is weak, it can not
turn stereo on.
2. Select stations
Briefly press rotate the TUNER KONB to tune the radio up or down by frequency step
0.05MHz.
Press or button on remote control to skip to the next or previous station.
Press NUMBER buttons on remote control to select the stations directly.
3.Store station presets
The steps are the same as in DAB mode, please refer to STORE STATION PRESETS of
DAB.
4. FM RDS information
Each time you press INFO button, the display will cycle through the follow contents:
<Program type>, <Station name>, <Stereo/mono>, <Radio text>, <Frequency>.
The display information is provided by the radio broadcasting stations. Some stations
may not provide.
5. Scan/Audio settings
a) Scan setting
(1) Press and hold MENU/INFO button, rotate TUNER KNOB to find <Scan setting>.
(2) Press ENTER to enter menu contents <Strong stations only>,<All stations>.
(3) Press ENTER button to confirm.
b) Audio setting
(1) Press and hold MENU/INFO button, rotate TUNER KNOB to find <Audio setting>.
(2) Press ENTER to enter menu contents <Forced mono>,<Stereo allowed>.
(3) Press ENTER button to confirm.
FM operation
Factory reset
To reset the unit in this section:
1. Press and hold MENU/INFO button, rotate TUNER KNOB to find <System> setting.
2. Press ENTER button to enter menu contents and find <Factory reset> setting.
3. Press ENTER to reset this unit.
11