Lenco L-175 - Manual (Page 27)

27
Safety instructions - continued
WARNING! NEVER INSERT AN OBJECT INTO THE PRODUCT
THROUGH THE VENTS OR OPENINGS. HIGH VOLTAGE FLOWS
THRU THE PRODUCT AND INSERTING AN OBJECT CAN CAUSE
ELECTRIC SHOCK AND/OR SHORT CIRCUIT INTERNAL PARTS.
FOR THE SAME REASON, DO NOT SPILL WATER OR LIQUID ON
THE PRODUCT.
Do NOT use in wet or moist areas such as bathrooms, steamy
kitchens or near swimming pools.
Do not use this device when condensation may occur.
This tablet is produced according to all current safety regulations. The
following safety tips should safeguard users against careless use and
dangers involved with such use.
Although this device is manufactured with the utmost care and
checked several times before leaving the factory, it is still possible that
problems may occur, as with all electrical appliances. If you notice
smoke, an excessive build-up of heat or any other unexpected
phenomena, you should disconnect the plug from the main power
socket immediately.
This device must be well ventilated at all time!
This device must operate on a power source as specified on the
specification label. If you are not sure of the type of power supply used
in your home, consult your dealer or local power company.
The socket outlet must be installed near the equipment and must be
easily accessible.
Do not overload AC outlets or extension cords. Overloading can cause
fire or electric shock.
Always hold the plug when pulling it out of the main supply socket. Do
not pull the power cord. This can cause a short circuit.
Avoid placing the device on any surfaces that may be subject to
vibrations or shocks.
When the device is not in use for long periods, unplug the AC power
cable for safety reasons.
To clean the device, use a soft dry cloth. Do NOT use solvents or
petrol based fluids. To remove severe stains, you may use a damp
cloth with dilute detergent.
The supplier is not responsible for damage or lost data caused by
malfunction, misuse, modification of the device or battery replacement.
The USB memory stick should be plugged into the unit directly.
Don’t use an USB extension cable because it can cause
interference resulting in failing of data.