Lenco L-175 - Manual (Page 5)

5
Place the record here when playing.
7. 33/45 RPM Switch (33/STOP/45):
Select 33 or 45 rpm for playing a vinyl, switch to “STOP” to pause the
playing. Switch to 33 or 45 again, to continue the playing from the
pause point.
8. Signal Connectors
Plug in the RCA cable, and connect the cable to audio amplifier.
9. Pre-Amp ON/OFF selector
* ON: Connect the RCA cable to LINE-IN terminal of amplifier.
* OFF: Connect the RCA cable to PHONO-IN terminal of amplifier.
10. USB port
Connecting to PC for recording the music from vinyl to PC.
- With Full-Speed Transceivers
- Fully Compliant With USB 1.1 Specification
11. Auto Stop Switch
While the tone arm playing to the end of the record, it will automatically
stop. The records have various ending points, if the record is auto-stop
before playing to the end, please switch off the auto-stop function.
12. Power supply jack:
To plug-in DC24V/1A switching adaptor for power supply.
13. Power Switch:
During PAUSE mode (33/STOP/45 switch is on “STOP” position), the
motor is still activated, switch off the player after use to save energy.
When installing the L-175 please make sure not to place it directly on top
of your Amplifier. (Amplifiers are known to cause hum noise on turntables.)