Altera Transceiver Signal Integrity - Manual (Page 38)

6–14 Chapter 6: Board Test System
Using the Board Test System
Transceiver Signal Integrity Development Kit, February 2013 Altera Corporation
Stratix V GT Edition User Guide
The Amphenol Tab
The Amphenol tab allows you to run a x4 backplane loopback test through the
Amphenol connector.
Figure 6–7 shows the Amphenol tab.
1
No external loopback is provided. A loopback backplane can be purchased from
Amphenol.
The following sections describe the controls on the Amphenol tab.
Status
■ The Status control displays status information during the loopback test. For
details on this control, refer to
“Status” on page 6–11 .
Port
The Port control allows you to specify the type of test to run on the Amphenol port.
The following Amphenol port test is available:
■ Amphenol x4 Transceivers
Figure 6–7. The Amphenol Tab