Altera Transceiver Signal Integrity - Manual (Page 43)

Chapter 6: Board Test System 6–19
Using the Board Test System
February 2013 Altera Corporation Transceiver Signal Integrity Development Kit,
Stratix V GT Edition User Guide
■ GTB Transceivers 3 —GT channel 3
PMA Setting
The PMA Setting button allows you to make changes to the PMA parameters that
affect the active transceiver interface. For details, refer to “PMA Setting” on
page 6–12 .
Data Type
The Data type control specifies the type of data contained in the transactions. For
details, refer to
“Data Type” on page 6–12 .
Error Control
This control displays data errors detected during analysis and allows you to insert
errors. For details, refer to
“Error Control” on page 6–13 .
Loopback
This control allows you control and analyze loopback performance. For details, refer
to
“Loopback” on page 6–13 .