Tow-starting (emergency engine starting), Electrical fuses, Important safety notes – Mercedes-Benz 2012 A Class User Manual

Page 316: Before replacing a fuse, Breakdown assistance

Advertising
background image

Tow-starting (emergency engine

starting)

!

Do not tow-start vehicles with automatic

transmission. You could otherwise damage
the automatic transmission.

Before tow-starting, the following conditions
must be fulfilled:

R

the battery is connected.

R

the engine has cooled down.

R

the exhaust system has cooled down.

X

Switch on the hazard warning lamps
(

Y

page 108).

X

Fit the towing eye (

Y

page 311).

X

Secure the rigid towing bar or the towing
rope.

X

Depress and hold the brake pedal.

X

Turn the key to position

2 in the ignition

lock.

X

Depress the clutch pedal and keep it
depressed.

X

Engage neutral.

X

Release the brake pedal.

X

Tow-start the vehicle.

X

Engage second gear.

X

Release the clutch pedal slowly without
depressing the accelerator pedal.
The engine is started.

X

Depress the clutch pedal and shift to neu-
tral.

X

Stop at a suitable place.

X

Secure the vehicle by applying the electric
parking brake.

X

Remove the rigid towing bar or towing rope.

X

Remove the towing eye (

Y

page 312).

X

Switch off the hazard warning lamps.

When tow-starting, it is important that you
observe the safety instructions (

Y

page 310)

and the legal requirements for the relevant
countries.

Electrical fuses

Important safety notes

G

WARNING

If you manipulate, bridge or replace a faulty
fuse with a fuse of a higher amperage, the
electric cables could be overloaded. This may
result in a fire. There is a risk of an accident
and injury.
Always replace faulty fuses with specified new
fuses of the correct amperage.

!

Only use fuses that have been approved

for Mercedes-Benz vehicles and which
have the correct fuse rating for the system
concerned. Only use fuses marked with an
"S". Components or systems could other-
wise be damaged.

The fuses in your vehicle serve to disconnect
faulty circuits. If a fuse blows, all the compo-
nents on the circuit and their functions will
fail.
Blown fuses must be replaced with fuses of
the same rating, which you can recognise by
the colour and fuse rating. The fuse ratings
are listed in the fuse allocation chart.
If the newly inserted fuse also blows, have the
cause traced and rectified at a qualified spe-
cialist workshop, e.g. a Mercedes-Benz
Service Centre.

Before replacing a fuse

X

Secure the vehicle against rolling away
(

Y

page 162).

X

Switch off all electrical consumers.

X

Turn the key to position

0 in the ignition

lock and remove it (

Y

page 143). All indi-

cator lamps in the instrument cluster must
be off.

The fuses are located in various fuse boxes:

R

fuse box in the engine compartment on the
left-hand side of the vehicle, when viewed
in the direction of travel

R

fuse box in the front-passenger footwell

314

Electrical fuses

Breakdown assistance

Advertising