Wheel and tyre combinations, General notes, Wheels and tyres – Mercedes-Benz 2012 A Class User Manual

Page 331

Advertising
background image

X

Tighten the wheel bolts until they are fin-
ger-tight.

Lowering the vehicle

G

WARNING

The wheels could work loose if the wheel nuts
and bolts are not tightened to the specified
tightening torque. There is a risk of accident.
Have the tightening torque immediately
checked at a qualified specialist workshop
after a wheel is changed.

X

Place the ratchet ring spanner onto the
hexagon nut of the jack so that the letters
AB are visible.

X

Turn the ratchet ring spanner until the vehi-
cle is once again standing firmly on the
ground.

X

Place the jack to one side.

X

Tighten the wheel bolts evenly in a cross-
wise pattern in the sequence indicated
(: to A). The tightening torque must be
130 Nm.

X

Turn the jack back to its initial position.

X

Stow the jack and the rest of the vehicle
tools in the vehicle again.

X

Vehicles with AMG equipment: insert the

cover into the outer sill.

X

Check the air pressure of the newly fitted
wheel and adjust accordingly.
Observe the recommended tyre pressure
(

Y

page 321).

Wheel and tyre combinations

General notes

!

For safety reasons, Mercedes-Benz rec-

ommends that you only use tyres and
wheels which have been approved by
Mercedes-Benz specifically for your vehi-
cle.
These are specially adapted to the control
systems, such as ABS or ESP

®

and are

marked as follows:

R

MO = Mercedes-Benz Original

R

MOE = Mercedes-Benz Original Extended
(tyres featuring run-flat characteristics)

R

MO1 = Mercedes-Benz Original (only cer-
tain AMG tyres)

Mercedes-Benz Original Extended tyres
may only be used on wheels that have been
specifically approved by Mercedes-Benz.
Only use tyres, wheels or accessories tes-
ted and approved by Mercedes-Benz. Cer-
tain characteristics, e.g. handling, vehicle
noise emissions or fuel consumption, may
otherwise be adversely affected. In addi-
tion, when driving with a load, tyre dimen-
sion variations could cause the tyres to
come into contact with the bodywork and
axle components. This could result in dam-
age to the tyres or the vehicle.
Mercedes-Benz accepts no liability for
damage resulting from the use of tyres,
wheels or accessories other than those tes-
ted and approved.
Further information about wheels, tyres
and approved combinations can be
obtained from any qualified specialist
workshop.

!

Retreaded tyres are neither tested nor

recommended by Mercedes-Benz, since
previous damage cannot always be detec-
ted on retreaded tyres. As a result,
Mercedes-Benz cannot guarantee vehicle
safety if retreaded tyres are fitted. Do not
fit used tyres if you have no information
about their previous usage.

Wheel and tyre combinations

329

Wheels and tyres

Z

Advertising