Subaru 2009 Tribeca - Manual (Page 28)

1-4
Seat, seatbelt and SRS airbags
switch.
! Seat height adjustment (driver’s
seat)
To adjust the seat height, pull up or push
down the rear end of the control switch.
& Memory function (driver’s
seat – if equipped)
Two of your favorite seat positions can be
registered. Register the seat position with
button
“1” or “2” and retrieve the seat
position by pressing either button.
The following seat positions can be
registered:
. Forward/backward position of the seat
. Angle of seatback
. Angle of seat cushion
. Height of seat
! Registration of seat position
WARNING
. Never adjust the seat while driv-
ing to avoid the possibility of
loss of vehicle control and of
personal injury.
. Before adjusting the seat, make
sure the hands and feet of rear
seat passengers or luggage are
clear of the adjusting mechan-
ism.
1. With the selector lever in the “P”
position, adjust the seat position.
2. While pressing the “SET” button, press
the desired button “1” or “2”.
3. The chime sounds once, and the seat
position is registered.
! Retrieval of seat position
WARNING
. Never retrieve the seat position
while driving to avoid the possi-
bility of loss of vehicle control
and of personal injury.
. Perform the seat position retrie-
val before driving. Be sure to
confirm that the selector lever
position is in the
“P” position. Do
not drive until the retrieval of the
seat position is complete.
. Be sure to press the correct
button to retrieve your registered
seat position. If the seat position
is not optimum for you, it may
adversely affect your driving and
may reduce the effectiveness of
the seatbelt. That could result in
an accident involving serious
injury or death.
. When retrieving a registered seat
position, make sure the hands,
feet and possessions of rear seat
passengers are clear of the seat
adjusting mechanism.