NISSAN 2008 Titan User Manual

Page 264

Advertising
background image

4LO:

31 MPH (50 km/h)

1 (Low gear):
Use this position when climbing steep hills slowly

or slow driving through deep snow, sand or mud,

or for maximum engine braking on steep downhill

grades.
Do not downshift into the 1 position at speeds

over the following and do not exceed the follow-

ing speeds in the 1 position.

2WD and AUTO:

43 MPH (70 km/h) w/o tow mode
37 MPH (60 km/h) w/tow mode

4H:

43 MPH (70 km/h) w/o tow mode
37 MPH (60 km/h) w/tow mode

4LO:

31 MPH (50 km/h)

To move the selector lever:

: Shift while depressing the brake pedal
: Shift without depressing brake pedal

Shifting – column

After starting the engine, fully depress the brake

pedal and move the shift selector lever out of the

P (Park) position.

WARNING

Apply the parking brake if the selector

lever is in any position while the engine is

not running. Failure to do so could cause

the vehicle to move unexpectedly or roll

away and result in serious personal injury

or property damage.

If the key is turned to the OFF or ACC position for

any reason while the vehicle is in N (Neutral), or

any D (Drive) position, the key cannot be turned

to the LOCK position and be removed from the

ignition switch. Move the selector lever to the P

(Park) position, then the key can be turned to

LOCK.
P (Park):

CAUTION

To prevent transmission damage, use the

P (Park) or R (Reverse) position only when

the vehicle is completely stopped.

Use the P (Park) selector position when the ve-

hicle is parked or when starting the engine. Make

sure the vehicle is completely stopped. The

brake pedal should be depressed to move
the selector lever from N (Neutral) or any
drive position to P (Park).
Apply the parking

LSD0099

5-14

Starting and driving

REVIEW COPY—

2008 Titan (tzw)

Owners Manual—USA_English (nna)
10/12/07—debbie

Advertising